Fascia work along Fergus & Elora rooflines
Fascia is the board along the ends of the rafters, and D&D Exterior Finishing repairs and installs it in Fergus and Elora. Choices include custom-bent aluminum over sound wood, pre-formed aluminum, vinyl or new wood. The crew replaces any rotted board before wrapping. A free written estimate shows each choice.
In a community with heavy wet snow, spring melt and freeze and thaw cycles, the roof edge takes a beating. Fergus and Elora have mature trees along many streets, and leaves and seed pods collect at the eaves. That combination is what typically leads to fascia boards getting damp, soft and eventually rotten.
Why fascia fails and how it gets fixed here
Rot that starts at an overflow
Fascia rot usually begins where a trough has overflowed or leaked, or where ice has sat against the board. The crew traces the damp to its source rather than just changing boards, so the same edge does not rot again.
Wrapping only over sound wood
Aluminum wrapped over rot hides the problem and lets hangers pull out. On older houses with original wood, rotted lengths are replaced first, and sound ones are wrapped in custom-bent aluminum for a clean, paint-free edge.
A package with soffit
Fascia, soffit and the gutters above it are tied together visually and physically. On a house where all three are tired, doing them as one job gives matching colours and avoids opening the same roof edge twice, which is common for homes going through a larger exterior refresh.
Fascia cost follows the length of roof edge, whether wood has to be replaced, the wrap material and colour, and the roof's height and access. Photos of the roof edge help us prepare a free written estimate.
Fascia questions from Fergus & Elora homeowners
How do I know my fascia is rotting?
Look for peeling paint, dark staining, soft spots when pressed, or a trough that sags. Those usually point to moisture at the roof edge. A site visit confirms how far it goes.
Does D&D work on fascia in Fergus and Elora?
Yes. Wood replacement, aluminum wrapping and vinyl fascia are all offered in both communities. Call (519) 501-5003 and describe the roofline.
Aluminum or vinyl fascia?
Aluminum can be custom bent to fit your edge and comes in many colours. Vinyl is another low-upkeep option. Roofline, colour match to soffit and siding, and budget help settle it.
Should fascia be done with other roof-edge work?
Often, yes. Soffit and fascia are commonly replaced together, colour matched to what is above and below. Combined work avoids repeating setup and gives one consistent finish.











